FAQ

The following are examples of the typical questions regarding the Scale Manager 2.

• Q. Can Scale Manager 2 be affected by power cuts?
• A. Yes-In some cases the microprocessor can glitch after a power cut of 1 - 15 seconds. This will be indicated by the LEDs not functioning correctly - to correct the fault, switch off the unit for a minute, allowing the electronics to discharge fully, then switch on..
• Q. I live in a large house. Will Scale Manager 2 cope?
• A. Yes - Scale Manager 2 is designed to give excellent service in both large and small homes
• Q. What happens if the red light goes out?
• A. It indicates a power fault.
• Q. What does a flashing red light indicate?
• A. The unit is going through a self-diagnostic routine.
• Q. What does the red power light indicate?
• A. That power is getting to the unit.
• Q. If the green lights stop what does these indicate?
• A. The unit is not functioning correctly - switch off for a minute and restart
• Q.  If I buy Scale Manager 2, what maintenance will it require?
• A. None - just check from time to time the lights are cycling correctly.
• Q. I live in a flat with one major tank, will Scale Manager II operate?
• A. Usually but have a survey to make sure.
• Q. I think my pipes are plastic and covered in paint, will this be a problem?
• A. No, the magnetic pulses will not be affected.
• Q. Is Scale Manager 2 noisy when operating?
• A. No, nor is there any vibration.
• Q. I have seen some makes with just one connection to the pipes, why does yours have two?
• A. Scale Manager 2 is a belt and braces product and has two technologies each requiring its own antenna.

Next FAQ

<Back